Ugly construction attempt

My first attempt at building a circuit using the ugly construction technique. It's supposed to be a simple oscillator circuit using a J310 transistor.

Ugly construction oscillator circuit

One of the advantages of ugly construction is that if you're working from a schematic or circuit drawing, building is pretty easy. I found that soldering components to the copper clad required a bit of patience, because it's essentially a very large heat sink. Put the soldering iron on the copper clad, add solder until you get a good sized pool, leave the soldering iron in place and place the component.

For this particular circuit, Vcc is applied to the big resistor with the free lead and output is off the capacitor with the free lead. I soldered on a piece of wire to make the ground connection easier. Haven't applied power to test it out yet. Will see if it works later on.